Volvo Car Show mode

Disconnect Show mode

When disconnecting Show mode completely from the car it is necessary to complete the checklist below.

Not doing so may result in error codes being stored in the ECU’s of the car or some components to continue to be on. Use VIDA to check the car before delivering the car to an end customer.

  1. Switch the running lights to “0”.
  2. Press the “Hazard” button and keep it pressed for more than 15 seconds until the Show mode information is displayed in the DIM, while keeping the button pressed there are three choises alternating, “Information”, “Lockable” and “Shutdown”.
  3. Release the “Hazard” button when Shutdown is displayed.
  4. Wait for the message “Finished clearing DTC” and until the LED indications on the controller are off.
  5. Unplug the OBD connector and remove the controller from the car.
  6. Unplug the power supply unit mains supply and then the battery connectors.
  7. Remove the power supply unit from the car before starting the engine.

To activate Show mode after completing step 2 the controller must first be disconnected from the car and then reinstalled again.